62 LD-250 Platform User's Guide 20472-000 Rev B
3.7 Installing the Docking Station
3.
Lower the docking station down, so the two bolts on the back of the docking station
slide into the bracket, securing the docking station to the wall.
Floor-mount, without Floor Plate
Screw the base of the docking station directly to the floor, using three user-supplied screws. For
dimensions of the available holes in the base, refer to Figure 3-14. Omron recommends M5
self-tapping screws that are suitable for the substrate (wood, concrete, etc.)
Floor-mount, with Floor Plate (Temporary Use Only)
Use this method temporarily, and only for experimenting with docking locations. The docking
station does not ship with the floor plate attached, it is included in the same carton.
1.
Tip the docking station onto its back, so you can access the underside.
2.
Remove the two lowest screws (M4 x 12 flat-head), if present.
In the following figure, these screws are circled. The location of the third screw hole is
also circled.
3.
Attach the floor plate to the base of the docking station with three M4 x 12 flat-head
stainless steel screws.
Figure 3-15 Underside of Docking Station Foot, Showing Screw Locations
NOTE: These are the three locations for the M4 x 12 flat-head screws. Two are
already in place. Remove them before attaching the plate.
To Next Page
Loading...
