Omron MICROAir NE-U100 - Page 2

Medication Container, Mouthpiece, Mask and Mask adapter
• Wash the medication container, mouthpiece, mask, and mask adapter in distilled water and mild
(neutral) detergent.
• Rinse the medication container, mouthpiece, mask and mask adapter thoroughly with distilled water
and allow to air dry in a clean place.
Note: Remove the elastic band from the mask before cleaning.
Vibrating element and its surrounding surface
• Wash under running tap water.
Note: To prevent liquid from entering the device, make sure that the battery cover is locked in place.
Main Unit
• Clean the main unit by wiping it off with a (moistened) lint free cloth. Use a dry lint free cloth to wipe
the main unit dry.
• Never clean with benzene or thinner.
After Each Use
To prevent any remaining medication in the bottle from drying or adhering to the mesh cap,
follow these cleaning instructions.
1. Remove the mask adapter from the main unit by pressing both sides of the mask adapter.
2. Open the medication container and remove the mesh cap.
3. Discard the medication then re-install the mesh cap.
4. Fill the medication container with water and close the lid of the medication container. Nebulize the
distilled water for 1 to 2 minutes to prevent medication from drying and adhering to the mesh after
each use.
5. Open the lid of the medication container and remove the mesh cap from the medication container,
then disassemble the medication container from the main unit by rotating counter-clockwise and
pulling-up.
6. Cleanthedeviceaccordingtotheinstructionunder“2.1Beforeusingthedeviceforthersttime”.
For additional detail, consult the MICROAir Vibrating Mesh Nebulizer Instruction Manual –
Model NE-U100.