Omron NE1A-EDR01 - Page 61

44
Mitsubishi Ethernet Interface Module Settings Section 4-4
Initial Setting Set the TCP/IP communications timer value for using the Ethernet Module,
and make the DNS server settings for using the e-mail function.
Make the initial setting as shown in the following table.
Opening Settings For communicating with a remote device, make the settings related to connec-
tion open processing and buffer memory applications for fixed buffer commu-
nications.
The open settings are as shown in the following table.
Note For this item, be sure to make the same setting as shown in the Set-
ting column.
Send frame setting Select the frame format for transmission. Ethernet (V2.0)
TCP Existence Con-
firmation setting
Select the method for existence confirma-
tion for TCP protocol communications.
Use the KeepAlive
Item Contents Setting
Item Contents Setting
Response monitoring
timer
Set the response wait time. 100
Item Contents Setting
Protocol (See note.) Set the communications method (proto-
col).
UDP/IP
Fixed buffer (See
note.)
Select the application for using the fixed
buffer.
This setting is
made automati-
cally when pair-
ing open is set to
pairs.
Fixed buffer commu-
nication (See note.)
Select whether the protocol is to be
enabled when using fixed buffer communi-
cation.
No procedure
Pairing open (See
note.)
Select whether pairing open is to be
enabled.
Pairs
Existence confirma-
tion
Select whether existence of the object is
to be confirmed.
Confirm
Local station Port No. Set the location station port number. 0401 hex
Destination IP
address
Set the IP address for the remote device. 192.168.250.17
(NE1A-EDR01)
Dest. Port No. Set the port number for the remote device. FA00 hex
(64,000 decimal)