This section describes the procedure to place Conveyor A used in the equipment model in 1-3 Opera-
tions of Static Pick-and-place Equipment on page
1-5 as an example.
Additional Information
For information on setting up in the 3D Visualizer and translating the point of view, refer to the
Sysmac Studio 3D Simulation Function Operation Manual (Cat. No. W618).
1 Select 3D Visualizer
from the View menu on the main window of the Sysmac Studio.
The 3D Visualizer is displayed on the right side of the main window.
2 In the 3D Visualizer, select the imported 3D shape data with the mouse cursor and right-click it.
The menu commands are displayed.
Additional Information
When you move the mouse cursor on the 3D shape data in the 3D Visualizer, the name of the
3D shape data /ApplicationManager0/CAD Data0 is displayed.
3 Implementation Example of Static Pick-and-place Equipment
3-42
NJ-series Robot Integrated System Startup Guide (O049)
To Next Page
Loading...
