11-5
11 Automatic Clock Adjustment
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
11-2 Procedure to Use the Automatic Clock
Adjustment Function
11
11-2-3 NTP Display
The settings to use automatic clock adjustment are displayed in the Built-in EtherNet/IP Port Settings
Pane on the Sysmac Studio.
11-2-3 NTP Display
Setting Description Default
NTP server clock informa-
tion
Specify whether to get the clock information from the NTP
server and use it to update the clock time in the CPU Unit.
Do not get
Port No.
*1*2
Set the port number to use to connect to the NTP server
for automatic clock adjustment. It is normally not neces-
sary to change this setting.
123
Server specifying method
*1
Set the method to use to specify the NTP server from
which to get the clock information.
• IP address
• Host name
IP address
IP address Set the IP address of the NTP server. (Set this setting if an
IP address is set for the server specification type.)
None
Host name Set the host name of the NTP server (i.e., the domain
name of the host). (Set this setting if a host name is set for
the specification type.) (You can use up to 200 single-byte
alphanumeric characters, dots, and hyphens with up to 63
single-byte characters between dots.)
None
To Next Page
Loading...
