12 SNMP Agent
12-24
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
z SNMP Trap
z Trap 1
*
12-2-4 SNMP Trap Settings Display
Setting Description Default
SNMP trap Specify whether to use the SNMP trap (network error detection). If
the SNMP trap service is not enabled, SNMP traps are not sent to
the SNMP manager.
Do not use.
Port No. Set the port number to use to connect to the SNMP server. It is nor-
mally not necessary to change this setting.
162
Setting Description Default
Specifying method Set the specifying method for the SNMP manager destination
for SNMP traps.
• IP address
• Host name
IP address
IP address Set the IP address of the SNMP manager. (Set this setting if
the specifying method in the trap 1 settings is set to the IP
address
Option.)
None
Host name Set the host name of the SNMP manager. (Set this setting if
the specifying method in the trap 1 settings is set to the Host
name Option.) (You can use up to 200 single-byte alphanu-
meric characters, dots, and hyphens with up to 63 single-byte
alphanumeric characters between dots.)
None
Community name Set the community name. (You can use up to 255 single-byte
characters.)
public
Version Set the version of the SNMP manager.
• SNMP version 1: SNMPv1
• SNMP version 2C: SNMPv2C
SNMPv1
To Next Page
Loading...
