Omron NJ501-1300 - Page 52

1 Introduction
1-18
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
z Using the SNMP Agent
z Using BOOTP
1 Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
Section 12 SNMP Agent
• Set the SNMP settings.
• Set the SNMP trap settings.
↓
2 Check operation.
• Check the event log to see if the SNMP agent started.
1 Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
Section 5 Sysmac Studio
Settings for the Built-in Eth-
erNet/IP Port
• Set the BOOTP settings.
↓
2 Check operation.
• Check the event log to see if BOOTP started.
• Check the Online system-defined variable.