2-7
2 System Configuration
NJ-series CPU Unit Hardware User’s Manual (W500)
2-1 Basic System Configuration
2
2-1-2 CJ-series Unit Configuration
• Use only NJ-series Power Supply Units on NJ-series CPU Racks and Expansion Racks.
Operation is not possible if you use a CJ-series Power Supply Unit with an NJ-series CPU Unit
or an NJ-series Power Supply Unit with a CJ-series CPU Unit.
SD Memory Card
Note Refer to 3-2-1 Models and Specifications for details on SD Memory Cards.
I/O Control Unit
End Cover
Others
Model Card type Capacity Format
Number of over-
writes
HMC-SD291 SD Card 2 GB FAT16 100,000
HMC-SD491 SDHC Card 4 GB FAT32 100,000
Model Specifications
Current consump-
tion
Weight
5 VDC 24 VDC
CJ1W-IC101 An I/O Control Unit is required to connect an NJ-series
Expansion Rack to an NJ-series CPU Rack. The I/O Con-
trol Unit must be connected immediately to the right of
the CPU Unit. Connect to the I/O Interface Unit (CJ1W-
II101) on the Expansion Rack with a CS/CJ-series I/O
Connecting Cable.
0.02 A --- 70 g max.
Model Specifications
Current con-
sumption
Weight
CJ1W-TER01 The End Cover must be connected to the right end of the
NJ-series CPU Rack. (A Controller error in the major fault
level will occur if the End Cover is not connected to the
right end of the Rack.) One End Cover is provided with
the CPU Unit and with an I/O Interface Unit.
Included with the CPU Unit or
Expansion Unit.
Name Model Specifications
DIN Track PFP-50N Track length: 50 cm, height: 7.3 mm
PFP-100N Track length: 1 m, height: 7.3 mm
PFP-100N2 Track length: 1 m, height: 16 mm
PFP-M Stopper to prevent Units from moving on the track.
Two each are provided with the CPU Unit and with
an I/O Interface Unit.
Connecting cable for peripheral USB
port (to connect the Sysmac Studio)
Commercially avail-
able USB cable
USB 2.0 certified cable (A connector - B connec-
tor), 5.0 m max.
Battery Set CJ1W-BAT01 For CJ2 CPU Unit
Sysmac Studio
Standard Edition
SYSMAC-SE The Sysmac Studio is a Support Software pack-
age that provides an integrated development
environment to design, program, debug, and
maintain SYSMAC NJ-series Controllers. The fol-
lowing Support Software is included.
• Sysmac Studio
• Network Configurator
• CX-Integrator
• CX-Protocol
• CX-Designer
To Next Page
Loading...
