94
9 Download the application to the PLC.
10 Open Data Files from the tree structure and select the N7 (Integer Register) and double-click on the
N007000 register.
11 Connect the cable to the NQ-Series and PLC. Refer to A-4-1 NQ to AB SLC Series.
12 Enter 123 in the NQ-Series’ screen. If the connection has been correctly established the same value is
shown in RS Logix 500 software.
Note
The following messages are displayed on the NQ-Series’ screen if problems occur:
• !!! no connection
• ??? connection established, address unknown
To Next Page
Loading...
