96
9 Download the application to the PLC.
10 Open Data Files from the tree structure and select the N7 (Integer Register) and double-click on the
N00700 register.
11 Connect the cable to the NQ-Series and PLC. Refer to A-4-2 NQ to AB Micrologix Series. Connect the PLC
end MiniDIN port to the AB DF1 Micrologix 1000 PLC. Connect the NQ-Series’ male port of the cable to the
COM1 port of the NQ-Series.
12 Enter 123 in the NQ-Series’ screen. If the connection has been correctly established the same value is
shown in RS Logix 500 software.
Note
The following messages are displayed on the NQ-Series’ screen if problems occur:
• !!! no connection
• ??? connection established, address unknown
To Next Page
Loading...
