97
A-3-5 NQ with AB DF1 Compact Logix Driver and AB Compact
Logix L31
To perform a successful communication proceed as follows.
1 Right-click the Nodes folder and click Add....
2 Set all data as shown in the screenshot.
3 Create PLC tag with address N007000.
4Add a Data Entry object with tag address N007000 on screen1.
5 Download the application and firmware to the NQ-Series.
6 Open RSLogix 5000 .
7Click on New on file menu.
8 Create new project.
9 After PLC is selected above screen will be shown.
Click on the PLC model and select CH0-system protocol
Confirm if data is as shown below.
To Next Page
Loading...
