Omron NV Series - Start-Up Screen Tab Page

84
Setting the NV Configuration from the NV-Designer Section 6-2
6-2-7 Start-up Screen Tab Page
Open the Start-up Screen Tab Page from NV Configuration. Set the number of
the screen to display and the time until it is displayed after turning ON the
power supply. This function is useful when the time required for the PLC to
turn ON is longer than the time required for the PT. There will be no communi-
cations between the PLC and PT during the startup delay, so even if the PLC
takes longer to start a timeout error will not be displayed on the PT screen.
When the startup screen display time has elapsed, the screen number stored
in the first address of the Word Area in system memory that is set in the Basic
Setup of the NV Configuration will be displayed.
Note There will be no communications between the PLC and PT during the startup
screen delay time. Functional parts on the startup screen will not be displayed
during the startup screen delay time.
Item Description
Start-Up Screen No. Enter the number of the screen to display when the power sup-
ply is turned ON within the range given in parentheses. Click
the button next to the box and set the startup screen from the
dialog box that appears.
Delay Set the display time of the startup screen to between 0 and
255 seconds. Click the button next to the box and set the time
to display the screen from the dialog box that appears.