Omron Powli BU75RW - 2-3 Connecting the Equipment

BU75RW/BU100RW/BU200RW/BU300RW
2
15
Computer
BU300RW/BU300RW
To power supply
output receptacle
2-3 Connecting the equipment
●
Group control of power supply output
This function can be used with the UPS monitoring software included with the UPS.
The output receptacles of the UPS unit are separated into 3 groups: A, B, and C.
• The output start times for power supply output group B and C are independent of power supply
output group A, so they can be delayed or set to precede the output stop time.
• The output start/stop time control funtion is available when using the included “PowerAct Pro”
UPS monitoring software, “UPS Power Manager” or “SNMP/Web card”.
•
Output ON/OFF can be controlled with the included UPS monitoring software while the UPS unit is
operating.
• The delay settings and ON/OFF control described here can be performed independently for
power supply output group B and power supply output group C.
This function can be used to set the startup order of servers, peripheral devices, etc.
The output receptacles can also be forcibly turned ON/OFF remotely.
Caution
Do not connect devices with rated voltage of 100 to 120 VAC or higher.
●
The rated output voltage of this device is 100 to 120 VAC.
●
Overcurrent may damage the connected devices.
Before connecting the BU200RW and BU300RW to commercial power,
make sure the input terminal block cover is attached. Do not use the unit
without the cover attached.
●
Voltage is applied to the input terminal block when the unit is connected to the commercial
power source, which can result in electric shock.
Computer
To power supply
output receptacle
BU75RW/BU100RW