7. Using the UPS monitoring software and contact signal
60
7-1-1. Connect the UPS to a computer.
Cable: Included connection cable (RS-232C or USB)
* The RS232C and USB cannot be used at the same time.
<RS-232C>
<USB>
●
When using PowerAct Pro “UPS monitoring software for Windows/Linux”
"PowerAct Pro" UPS monitoring software
The included "PowerAct Pro" UPS monitoring software allows you to automatically save fi les and
perform shutdown processing of your PC when a power failure occurs.(It is possible to shut down
multiple computers on the network.)
Also, you can perform desired operation by setting the automatic start/stop of the UPS based on
the schedule setting.
* The time between the occurrence of a power failure and the shutdown of your PC must be
within the backup time measured in "5-1 How to measure backup time" on page 43.
For more information, refer to the Instruction Manual and online help of the UPS monitoring
software.
7-1
When using the included UPS monitoring
software to perform auto shutdown
Connector
Connector
Connector
Connector
USB
Port
USB
Port
Connect to
USB Port
on UPS
Connect to USB
port on PC
Connect to USB
port on PC
Included connection cable(USB)
Included connection cable(USB)
Connect to
USB Port
on UPS
Connect to
USB terminal
Connect to
USB terminal
BU200RW/BU300RW
Connect to
RS-232C
port on PC
Connect to
RS-232C
port on PC
Included connection cable(RS232C)
Included connection cable(RS232C)
To Next Page
Loading...
