Omron R88M-K - Page 677

A-127
Appendices
G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
A-3 Sysmac Error Status Codes
App
A-3-2 Error Description
Event name Object Corrupted Event code 14AB0000 hex
Meaning The checksum data in non-volatile memory is corrupted.
Source EtherCAT Master Function Module Source details Slave Detection
timing
When
establishing
communications
after turning ON
power to the
slave
Error attributes Level Minor fault Recovery Error reset (after
cycling slave
power)
Log category System
Effects User program Continues. Operation Power drive circuit is OFF for relevant slave.
Indicators EtherCAT NET RUN EtherCAT NET ERR EtherCAT LINK/ACT
--- --- ---
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Remedy Prevention
Non-volatile memory failure Replace the Servo Drive. None
Attached
information
None
Precautions/
Remarks
“37” is displayed on the Servo Drive front panel and F037 is given as the AlarmCode (4001 hex).
Event name Object Corrupted Event code 14AC0000 hex
Meaning The checksum data in non-volatile memory is corrupted.
Source EtherCAT Master Function Module Source details Slave Detection
timing
When
establishing
communications
after turning ON
power to the
slave
Error attributes Level Minor fault Recovery Error reset (after
cycling slave
power)
Log category System
Effects User program Continues. Operation Power drive circuit is OFF for relevant slave.
Indicators EtherCAT NET RUN EtherCAT NET ERR EtherCAT LINK/ACT
--- --- ---
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Remedy Prevention
Non-volatile memory failure Replace the Servo Drive. None
Attached
information
None
Precautions/
Remarks
“37” is displayed on the Servo Drive front panel and F137 is given as the AlarmCode (4001 hex).