6.3 Replacement of Cooling Fan
57
750 W SERVOPACKs
1. Open the case of the SERVOPACK.
Insert the tip of a straight-edge screw-
driver into the three notches on the
case and the two on the cover on the
SERVOPACK one by one and pry the
case off.
2. Pull the case and the cover off of the
SERVOPACK.
3. Disconnect the cable of the cooling fan
from the fan connector on the SERVO-
PACK.
Case
Front of
SERVOPACK
Pick the cable up,
and then pull it out.
Case
Cover
TOEP_C710806_01A_0_0.book Seite 57 Montag, 2. Juli 2007 4:24 16
To Next Page
Loading...
