EasyManua.ls Logo

Omron SmartSlice GRT1 Series - Page 334

Omron SmartSlice GRT1 Series
366 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
314
Explicit Messages Appendix A
Note (1) The Instance ID specifies the Slice I/O Unit’s unit number (1 to 64).
(2) Specifies input 0.
(3) Specifies input 1.
Setting and Reading for Analog Output Units
Sampling
Cycle Set-
ting
Write/
Read
Sets the sampling cycle
for obtaining the rate of
change based on the
previous value.
Write:
10 hex
Read:
0E hex
8F hex 01 to 40
hex
*1
86 hex
*2
AE hex
*3
GRT1-AD2:
2 bytes (10
to 65535)
GRT1-AD2:
2 bytes (10 to
65535)
Cumulated
Value Read
Read/
Reset
Reads the cumulated
analog input value.
Read:
0E hex
Reset:
35 hex
8F hex 01 to 40
hex
*1
87 hex
*2
AF hex
*3
4bytes
(214748364.8
to
214748364.7)
Cumulative
Counter
Flag Read
Read Reads the cumulative
count status in the
Cumulative Counter
Flag in the area for
Generic Status Flags.
0: Counter overflow
1: Counter underflow
7: Set value overflow
Read:
0E hex
8F hex 01 to 40
hex
*1
88 hex
*2
B0 hex
*3
1 byte
Cumulative
Counter
Monitor
Value Set-
ting
Write/
Read
Writes/reads the set
monitor value for the
cumulative counter.
Write:
10 hex
Read:
0E hex
8F hex 01 to 40
hex
*1
89 hex
*2
B1 hex
*3
4 bytes 4 bytes
Cumulative
Counter
Unit Setting
Write/
Read
Sets the unit for the
cumulative counter.
0: Hour (count hours);
1: Minute (count
minutes)
Write:
10 hex
Read:
0E hex
8F hex 01 to 40
hex
*1
8A hex
*2
B2 hex
*3
1 byte 1 byte
Explicit
message
Read
/write
Function Command Response
Service
code
Class
ID
Instance
ID
Attribute ID Data
Explicit
message
Read
/write
Function Command Response
Service
code
Class
ID
Instance
ID
Attribute
ID
Data Size
Setting the
Number of
DA Conver-
sion Points
Write/
Read
Sets the number of DA
conversion points.
Write:
10 hex
Read:
0E hex
90 hex 01 to 40
hex
*1
64 hex 2 bytes 1 byte
Analog Out-
put Value
Read
Read Reads analog output
values.
0E hex 90 hex 01 to 40
hex
*1
67 hex
*2
7D hex
*3
2 bytes
Output
Range Set-
ting
Write/
Read
Sets the output range.
4 to 20 mA: 0;
0 to 10 V: 1;
0 to 20 mA: 2;
10 to 10 V: 3;
0 to 5 V: 4;
1 to 5 V: 6
0E hex 90 hex 01 to 40
hex
*1
68 hex
*2
7E hex
*3
1 byte

Table of Contents

Related product manuals