on networks PL200 Powerline 200 User Manual

5
Install your Powerline adapter
For each Powerline adapter you are adding to
your existing Powerline network, do the
following:
1. Plug each Powerline adapter into a power
outlet.
2. Set up security on your Powerline adapter to
add it to your existing Powerline network.
Press the Security button for 2 seconds,
then press the Security button on one of the
other Powerline adapters in your existing
network for 2 seconds. Both buttons must be
pressed within two minutes.
Note: Do not press the Security button on the
Powerline adapter until installation is complete
and the adapters are communicating with each
other (indicated by the blinking Powerline LED).
Pressing this button too soon can temporarily
disable Powerline communication. If this situation
occurs, use the Factory Reset button to return
the Powerline adapter to its factory default
settings.

on networks PL200 Powerline 200 Specifications

General

Brand	on networks
Model	PL200 Powerline 200
Category	Network Hardware
Language	English