9. Factory Reset
Plug in the power cable and switch the toggle to Cable mode.
- Factory reset the keyboard by pressing fn + J + Z (hold for 4 seconds).
- Download the relevant rmware and QMK Toolbox from our website.
- Switch the keyboard to OFF mode and carefully remove the space bar keycap to nd
the reset button on the PCB.
- Holding the reset key, switch the toggle to Cable mode. Release the reset key, and
the keyboard will now enter DFU (Device Firmware Upgrade) mode.
- Flash the rmware using QMK Toolbox.
- Factory reset the keyboard again by pressing fn + J + Z (hold for 4 seconds).
Troubleshooting? Don’t know what’s going on with the keyboard? Step by step guide
can be found on our website.
11
To Next Page
Loading...