OneTouch Delica Plus Getting Started Guide

OneTouch
®
Delica
®
Plus lancing device
Make every test Virtually Pain Free
Getting Started Guide
Preparing your lancing device Testing and removing
the used lancet
Adjust the depth setting
Smaller numbers are for
a shallower puncture and
larger numbers for a deeper
puncture.
4
5
Eject the lancet
Holding the lancing device
downwards, push the slider
forward until the lancet comes out.
Push the cap back onto the device.
Remove the lancing
device cap
1
Puncture your finger
Hold the lancing device firmly
against the side of your finger.
Press the release button to
puncture.
1
Insert a sterile lancet
into the lancing
device and remove
its protective cover
2
Remove the lancing
device cap again
3
Apply the sample
Apply the blood sample following
the instructions in your OneTouch
®
Owner’s Booklet for proper sample
application.
2
Replace the lancing
device cap
3
Cover the exposed lancet tip
Place the lancet protection cover on
a hard surface and push the lancet
tip into the flat side of the disk.
4
6
Replace the lancing
device cap
Discard the used lancet carefully
after each use to avoid unintended
lancet stick injuries.
5
Cock the lancing device
by sliding the button
back until it clicks
Now you can test
Before using the OneTouch
®
Delica
®
Plus lancing device to test blood glucose, carefully
read the OneTouch
®
meter Owner’s Booklet and inserts that come with the system.
Use with OneTouch
®
Delica
®
Plus or OneTouch
®
Delica
®
lancets.

OneTouch Delica Plus Specifications

General

Test Time	5 seconds
Measurement Range	20-600 mg/dL
Memory	500 test results
Battery	One 3V lithium battery (CR2032)
Operating Conditions	10-90% RH
Storage Conditions	-20-60 °C, 10-90% RH