OneTouch Verio Reflect - Viewing Your Control Solution Result

72
3
Taking a test
Viewing your control solution result
Example
Control
Solution
mmol/L
6:30 amJul 4
6.7
After the control solution
is applied, your meter will
display a progress screen for
approximately 5 seconds. Your
result is displayed along with
the date, time, unit of measure,
and (for control solution).
Control solution results are stored in the meter and can
be seen when reviewing past results on the meter.
CAUTION:
Make sure you select Control Test from the Settings
Menu before you begin a control solution test. Follow
the steps beginning on page page68. If
does not
appear on the screen, this result will be included in your
averages and your averages will change too. Repeat the
test with a new test strip. If the problem persists, contact
Customer Care. Contact information for Customer Care is
listed at the end of this Owner's Booklet.