ONIKUMA K10
Instrukcja obsługi / User Manual
7
Device maintenance
1. Any damage caused by improper use or attempted repair is not covered by the warranty. There are
no service parts inside the packaging, repairs may only be carried out by authorized service center.
2. Do not allow the device to come into contact with oil, grease or any similar liquid.
3. Regular cleaning allows of long term use and maintains proper operation. Use a soft cloth to clean
the device.
Device operation
1. The headphones are compatible with both audio devices with a single 3.5mm jack headphone output
and devices with a 3.5mm jack headphone output and a 3.5mm jack microphone input. Examples
of such devices are laptops, tablet PCs or smartphones.
2. When putting on the headphones, make sure that the cable is on the left side. Connect the cables
(headphone, microphone and USB) to the corresponding inputs/outputs of the audio device.
3. The headphones will be automatically recognized by the audio device, and the driver will be auto-
matically installed. When using the headset with a computer, make sure the microphone switch
is turned on. If the headset does not work properly, go into the sound settings and set the correspond-
ing output device (headphones) and input device (headphone microphone).
4. Set the preferred headphone volume.
Technical specification
Type: gaming headphones for gamers
Compatibility: Windows, Mac, Android, iOS
Design: closed, on-ear
Transducer diameter: 50 mm
Impedance: 32 Ω
Power consumption: < 100 mA
Sensitivity: 105 dB (±3 dB)
Frequency range: 20 - 20000 Hz
Microphone: built-in (6 x 2.7 mm)
Microphone sensitivity: -42 dB (±3 dB)
Microphone on/off switch: remote control on cable
LED lighting: RGB
Communication: wired
Wire length: 2,2 m
Information about used electrical and electronic equipment
The main goal of European and national law regulations is to reduce the amount of waste produced
from used electrical and electronic equipment, to ensure an appropriate level of collection, recovery
and recycling of used equipment, and to increase public awareness of its harmfulness to the environ-
ment, at each stage of use of electrical and electronic equipment. Therefore, it should be pointed out
that households play a key role in contributing to reuse and recovery, including recycling of used equip-
ment. The user of electrical and electronic equipment – intended for households – is obliged to return
it to authorized collector after its use. However, it should be remembered that products classified
as electrical or electronic equipment should be disposed of at authorized collection points.
To Previous Page
Loading...