Onix KZ3001 - Page 2

1
2
3
4
5
7
6
1
2
3
Before assembly make sure you have enough room to put the net together. The net assembly is 22 feet (6.7m) wide, a
standard pickleball court is 20 feet (6.1m) wide and 44 feet (13.41) long. See Page 4 for an Illustration of the Court.
SET-UP:
5
7
5
Detail B
5
5
5
8
6
7
Detail A
Spring Lock
Start with this End Base
1. Take all components out of the case and sort them, all items are labeled.
a. Set End Base (#1) on a hard flat surface, insert Net Support Tube (#2) and Angled Tube Support (#3).
b. Insert the Short Support Tube (#4) to tube (#3) followed by two Long Support Tubes (#5).
c. Insert “T” Support Tube (#7) to Middle Base (#6) until the spring lock engages in to the hole on the Middle Base. See Detail A.
d. Slide Middle Base Tube assembly over Support Tube (#5) from Step b. Then insert another (#5) Support Tube as shown in Detail B.
c. Complete the frame assembly by connecting another (#5), tubes (#8), (#3), End Base (#1) and Net Support Tube (#2)
-2-