SN 29344085
Printed in Japan
I0504-1
(C) Copyright 2005 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 3 4 4 0 8 5 *
■
What to do if you’ve already got a cassette deck, MD recorder, CD recorder, or other component con-
nected to the TAPE IN jacks:
To connect and control with the remote controller both the already connected component and the RI Dock,
consider the following two options. Note that the Direct Change function will only work with the TAPE input.
Choose one of the following options based on which device you use the most.
Option 1:
Connect the RI Dock to the LINE IN, TAPE2 IN, VIDEO IN, or another audio input.
Option 2:
Connect your cassette deck, MD recorder, or CD recorder to the LINE IN/OUT, TAPE2 IN/OUT, VIDEO
IN/OUT, or another audio input and output, and connect the RI Dock to the TAPE IN.
If you choose option 2 and connect the previously connected component to another input, do not disconnect
its RI connection. If it’s a cassette deck, remember to change your amp’s source display from TAPE to MD or CDR
as appropriate. (Press and hold your amp’s [TAPE] button to do this.)
Whichever option you choose, be sure to set the RI Dock’s RI MODE switch so that it matches the remote con-
troller’s remote mode, and use a different remote mode for the other component.
With amps such as the TX-SR500 and TX-SR501 that have a TAPE remote mode but not an MD or CDR remote
mode, it’s not possible to control both the RI Dock and the other component with the remote controller. In this
case, you’ll need to operate one of them by using its own controls.
Supported AV Receivers Page 2 Monday, April 25, 2005 10:44 AM
To Previous Page
Loading...
Need help?
General
