DV-S757
COND.
M
CH
+
CH
-
FUNCTION M
SEARCH
23
456
789
1
0
+
10
+
-
TV/
VCR
VOL
+
VOL
-
TV
LAST M DIMMER DISPLAY
ANGLE
STANDBY
AUDIO SUBTITLE
MENU
TOP MENU
SETUPRETURN
PAUSE
DOWN UPFR FF
CLEAR
PROGRAM
DVD
RANDOM REPEAT A
-
B
STEP/
SLOW
ENTER
KEY
B
4
5
6
TVDVD
Setting
TV
position
[Player's ID Number Setting]
ID Number
[000000001]
compare
>
<CLEAR> Exit
Input ID Number !
*********
000000001
TVDVD
Setting
TV
position
UPGRADE FIRMWARE-4
It is necessary to set up an individual number (ID number and ID data) for every player in the
DVD audio correspondence player.
The guarantee of operation becomes impossible if this ID number and ID data are not set up correctly.
About ID number and ID data input
It is the following case that the input of ID number is required.
1. After download of the data to the flash ROM of the unit.
2. When displayed on FL display as "No ID Number "after turning ON the power supply of the unit.
3. When displayed on FL display as "No ID DATA".
Check ID number.
Set-up ID number is displayed.
This ID number is recorded
in the memorandum.
It is displayed also on FL display.
6. Press the B button, and check mode is ended.
The input of ID number is needed by the work of rewriting of a farm.
Make a note by checking ID number of a set with the following procedure first.
4. Press and hold down CLEAR button, then press the KEY button of remote controller.
5. Press the VOL+ button.
1. Check the connecting the unit to PC and monitor TV.
2. Switch ON the power of unit.
3. Check that the disk is not contained in the unit.
Check the firmware
1. Press the SETUP key
2. Operate the CURSOR switch to make up the Setup menu mode are selected on monitor TV.
3. Press the DISPLAY button
The region and FW version information will appear on the monitor TV.
TV Monitor
FL Display
To Next Page
Loading...
