Onkyo DX-6930 User Manual

DESCRIPTION
Focus OK input
) Output filter changeover output of spindle motor
) Hoss Spindle motor control output
Spindle motor servo control
Spindle motor servo control
iH when GFS is high
Oscillation circuit output for analog FEM PLL
Oscillation circuit input for analog EFM PLL
(8. 6436MHz)
Test terminal
Charge pump output for analog EFM PLL
Ground terminal
PLL charge pump output for variable pitch
‘Clock input for variable pitch from VCO
(16. 934MHz)
Filter output for master PLL
Filter input for master PLI,
Charge pump output for master PI.L.
Reape?”
Analog ground
vco control voltage input for master
AVDD bee Analog section power supply (+5V)
fa EFM signal input
TEST Connect to the ground.
Connect to the ground.
EFM full swing output
Connect to the ground.
) Audio data output mode changeover input.
Serial data at L. and paraller data at H.
D/A interface for 48 bits slot. Word clock {=2Fs.
D/A interface for 48 hits slot. I.R clock f{=Fs.
Power supply terminal (+5V)
Data output terminals
Serial data of 64 bits slot
; Bit clock of 68 bits slot
A 38 ’ y LR clock of 68 bits slot
ro [Dain
Note:SSP:Q104 CXA1372S
LA6510 (Power OP Amp)
DAO8
DA07
| DAOG
DA05
DAO4
DAV3
DA0Z2
CHM |
Digital output
DESCRIPTION
DAO’ _|_GFS output
‘DAO RFCK output
“C2PO0 output ons
~ XRAOF output
~ MNT3 output
$43. SGHYMHz input
Crystal oscillation circuit output of 16. 9344 MHz
Crystal selection input terminal. 1. when
16. 931UMHz. H when 33. 8688MHz.
2/3 divided output of pins 53 & 54
4.2436MEz output
16. 93 14Milz output
Digital output control input. On at HW & Off at L..
Emphasis contro! output. Active H.
Write frame clock output
Sub-code detection output. HH when is detected SO ur
Sl.
‘Serial output of sub code(P~W)
Clock input for read out SBSO
Sub Q 80 bits. PCM peak. and level data 16) bits
output
Clock input for read out SQSO
Muting control output. Active HH.
Sens output. Output to microprocessor
System reset. Rest at low level.
Seria! data input from microprocessor
Latch input from microprocessor. J.atch the serial
data at trailing.
Power supply
Serial data transfer clock input (rom microprocessor
Sens input from SSP
Track jump numbers count signal input
Serial data output to SSP
Serial data latch output to SSP. Latch at trailing.
Serial data transfer clock output to SSP
Mirror signal input
DX-6930
DX-6920
SM5861AP (D/A converter)
INFINITE INPUT TIMING
ZERO CONTROL
DETECTOR SECTION
OPERATION
TIMING
CONT ROL
INPUT
MUTEL
INTERFACE (5) E
INTERNAL
LINEAR SYSTEM CLOCK
INTERPOLATION rc 6) cKO
OPERATION
SYSTEM
CLOCK
XOIVN
XVO0O0
POWER
SUPPLY FOR PWM DATA GENERATION
DIGITAL
POWER
POWER
SUPPLY FOR palatal
ANALOG FOR ANALOG
BCKI Serial input data bit clock AVDD3 _[5V supply for analogue section
WCKI Input data word clock ee Data output
AVSS2 Ground for analogue section
RO —s*|Dataoutput
Ge Mec eet ee ee el
Crystal oscillator input
Crystal oscillator output
2
2
2 XDIVN System clock select
2
2
:
|
<
~”N
pale Q
round for analogue section | 26 |CKO [Clock output
| 13, |LON [Dataoutput SSCS SSDINE Serial data input for left channel
5V supply for analogue section | 28 {DINR erial data input for right channel
16
17
18
19
20
21
ZZ
3
4
5
6
Z
28
Cg)

Onkyo DX-6930 Specifications

General

Brand	Onkyo
Model	DX-6930
Category	CD Player
Language	English