Onkyo DX-C106 - Page 16

DX-C206
DX-C106
The following is a simple adjustment method. 5. Connect oscilloscope to RF/ Servo board TP (TE).
6. Adjust RV101 so that the waveform is as shown in
~ Simple Adjustment —
the figure below. (tracking gain adjustment)
Note: Since exact adjustment cannot be performed, remem-
ber the positions of the controls before performing the
adjustment. If the positions after the simple adjust-
ment are only a little different, return the controls to
the original position.
VOLT/DIV: 1V
TIME/DIV: 2mS
— dv
oscilloscope
(DC range)
Procedure:
main board
a
TP (FEO) Q<-——zy——_—© +
i @ Incorrect Examples (fundamental wave appears)
fe
TP (TEO) Ow- ~7 low tracking gain
1. Keep the set horizontal.
If the set is not horizontal, this adjustment
cannot be performed due to the gravity against
the 2 axis device.
Insert disc (YEDS-18) and press PD PLAY button.
Connect oscilloscope to RF/ Servo board TP (FE).
VOLT/DIV: TV
TIME/DIV: 2mS
—ov
tw
Adjust RV102 so that the waveform is as shown high tracking gain
(higher fundamental wave than for low gain)
in the figure below. (focus gain adjustment)
- &
VOLT/DIV: IV
TIME/DIV: 2mS
VOLT/DIV: 100 mV
TIME/OIV: 2mS
W—s00mvy
OV
@ [ncorrent Examples (DC level) changes more than
cn adjusted waveform) .
Adjustment Location: RF/ Servo board
low focus gain
VOLT/DIV: 100 mV
TIME/OIV:
2mS
[Victos
—
250mV
-
O0
RVIO2
FE
FO
GAIN
ov
On
high
focus
gain
VOLT/DIV.
100
vio
TIME/DIV) 2mS