HTX-22HD
FIRMWARE UPDATE -2
Main microprocessor (Continued)
* It depends on the version.
Search F/W...
FW Update 01000
FW Update 02000
OK : Sum=F9239467
This information will appear when
the click of [Main Update] is accepted.
[Main Update Procedure]
1. Make sure that the unit is on.
2. Double-click "Update.exe" in the unzipped folder "Update_DHT9HD_M_101".
The following window will appear. (Folder name depends on the version.)
3. Click "Main Update" button to start update. It takes about 3 minutes.
The message on Front Display will change as follows.
4. After update completes, the unit will not accept any operations. Unplug the power code and remove the jig from the unit.
<NOTE>
Customer settings will be overwritten by the default settings.
Audyssey 2EQ setting will be necessary again after update because EQ settings set by Audyssey 2EQ cannot
be displayed to take a memo for manual setting.
5. Turn on the unit and initialize it by holding down [LISTENING MODE] button and then pressing [STANDBY/ON] button.
Confirm the new version number.
To Next Page
Loading...
