Onkyo HTX-22HD - Page 31

HTX-22HD
FIRMWARE UPDATE -3
DSP
Writing...
DSPHT205 : 08327A
Main1.00/08407A
HTX-22HD Rear Panel
Clear
Complete!
Standby mode
1st push
2nd push
3rd push
4D44K1N/2FF?x4
Digin: AUTO
S/PDIF Update..
* It depends on the version.
* It depends on the version.
(Target unit)
[Preparation for Update (DSP)]
Update is done by playback of CD-R in a CD player.
<Tool>
1. Blank CD-R : 1 pc, PC (Personal computer with CD-R writer)
2. Writing soft : "CD_DHT9HD0_08618A.wav" (File name depends on the version.)
<NOTE>Store the wav file in a blank CD-R as a music CD in advance.
* For a writing soft, contact Onkyo or your local distributor.
3. CD player with Optical or Coaxial output terminal : 1 pc
<NOTE>Some CD players and a lot of DVD players process audio signal before output.
Such players cannot be used for this update.
4. Optical cable or Coaxial cable : 1 pc
<Connection>
1. Connect a CD Player with a target unit via Optical Input 1 or Coaxial Input.
2. Turn on the unit and wait for more than 10 seconds.
[DSP Update Procedure]
1. Set MASTER VOLUME value to 10.
2. Hold down [INPUT] button and then press [STANDBY/ON] button.
Main FW version will be displayed.
3. Press [LISTENING MODE] button.
DSP FW version will be displayed.
4. Press [INPUT] button 3 times, and the unit will be ready to receive data from CD player.
5. Press [PLAY] on CD player. After playback ends (about 18 sec.), writing will start. It takes about 40 sec..
<NOTE>
(1) If the above message does not appear after waiting for a while, please try again.
Some DVD players are not suitable for this update. If writing results in failure, use another model of player.
(2) DURING WRITING, DO NOT TURN OFF THE POWER and DO NOT DISCONNECT OPTICAL/COAXIAL CABLE.
If writing is stopped in the middle, Flash IC may need replacing.
6. After writing ends, the unit will be automatically initialized and put into the Standby mode.
7. Turn on the unit and confirm the new version number.