Onkyo TX-8020 - Configuring Speaker Impedance

Connecting the
Receiver-Continued
On
the receiver, the factory default for speaker impedance is
"6
Q".
If
you need to change the speaker impedance setting,
read
"Speaker
Connection
Pr
ecautions"
on page
11
carefully before performing the procedure below.
<!.)--@
eee
00
BASS
TREBLE
[!]][!]][38
1\
v
< >
-
H-
---.-.
BBJEl
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
1
Press the
[C>]
button to turn on the power.
2
Press the [SETUP] button on the remote
controller.
3
Use the arrow
[J\]I[V]
buttons to select
"SP
Impedance," and then press [ENTER].
4
Change the impedance value to
"4
Q"
using
the arrow [
<]![>]
buttons.
5
Press the [ENTER] button
to
confirm the
setting.
If
you want to change the impedance setting back
to the factory default setting
of
6
n,
follow the
same procedure described above.
6 Press the [SETUP] button on the remote
controller
to
complete the setting.
Notes:
•
This procedure can also be performed on the receiver
by using
[SETUP],
TUNING
[i]/[T],
PRESET
[
.....
]/[
....
],and
[ENTER].
• Press
[RETURN] to return
to
the previous menu.
•
This
procedure will be cancelled
if
the
[S
ETUP]
button is pressed before step
5.
Setting
example:
If
you're using only one
of
the speaker sets connected to
SPEAKERS A
orB,
choose the
4
Q
setting
if
each
speaker's impedance is
4
Q
to less than
6
Q,
or
choose
the 6
Q
setting
if
each speaker's impedance is 6
Q
or
more.
If you're using both
of
the speaker sets connected to
SPEAKERS A and B, choose the 4
Q
setting
if
each
speaker's impedance is 8 to 16
n.
En-13