Connecting Your Components-Continued
See "Recording" for an explanation
of
recording (
~
page 23).
Analog audio cable
= =
Cassette tape deck, CDR, etc.
Notes:
• The receiver must
be
turned
on
for recording. Recording is not possible while
it's
in Standby mode.
•
For
European model, sources connected to a digital input cannot be recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so
don't
attempt analog recording
of
DTS CDs
or
LDs.
Connect the receiver's power cord to a suitable wall outlet.
Notes:
• Before connecting the power cord, connect all of
your
speakers and components.
• Turning on the receiver may cause a momentary power surge that might interfere with other electrical equipment
on
the same circuit.
If
this is a problem, plug the receiver into a different branch circuit.
En-18
To Next Page
Loading...
