Onkyo TX-8020 - Tuning AM;FM Stations; Direct Frequency Tuning

Listening to the Radio-Continued
Listenill9: to AMIFM stations
With the built-in tuner, you can enjoy AM and FM radio
stations.
1 Use the receiver's [INPUT] selector, or the
remote controller's INPUT SELECTOR
buttons to select AM or FM.
In this example, FM has been selected.
Band Frequency
1
--- 1 --------,
). .. ···. '· ·'' '
r::·r·! :::::/" :::::i:::ii'ii· .. i:;::: ......... .
(Actual display depends on the country.)
2 Press the [TUNING MODE] button so that
the AUTO indicator appears or disappears
from
the display.
AUTO indicator
....------------1-----,
: ::
Auto Tuning
To activate this mode, press the [TUNING MODE]
button to turn on the "AUTO" indicator. In this
mode, you will receive the broadcast in stereo
sound.
Manuall\ming
To activate this mode, press the [TUNING MODE]
button to turn off the "AUTO" indicator. In this
mode, you will receive the broadcast in monaural
sound.
3 Press the TUNING [!] or [T] button.
You can also use the remote controller's arrow
[1\]/[V] buttons to tune the radio.
Auto Tuning
Searching stops when a station is found.
Manual Tuning
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the
frequency one
st ep at a time.
The frequency changes in 0.05 MHz steps (or 0.05 MHz
to 0.2 MHz for North American model) for FM, and
9kHz (or 10kHz) steps for AM.
When tuned to a station, the TUNED indicator appears.
When tuned to a stereo
FM station, the FM STEREO
indicator also appears.
TUNED FM STEREO
.J.~l ' -. ---.,
Tuning to Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
• Tuning into Stations by Frequency
You can tune to AM and FM stations directly by entering
the appropriate frequency.
1 Press the remote controller's [D. TUN] button
twice.
' ' '
............... :: .......... : :: :.: ........... ..
(Actual display depends on the country.)
2 Within 8 seconds, use the number buttons
to enter the frequency of the radio station.
For example, to tune to 87.50 (FM), press 8, 7, 5, 0.
En-25