Onkyo TX-8210 - Adjustment Procedures; Preparation and Inputs;Outputs; Standard Knob Positions; Idling Current Adjustment

Receiving stations
Please make sure that the TAPE-2 MONI-
TOR indicator is off and audio muting is
off.
When the frequency is not known -Man-
ual tuning
1. Press the FM or AM button.
2. Use the < DOWN TUNING UP >
buttons to change the frequency.
UP we. the frequency increases.
DOWN .... the frequency decreases.
@ The frequency is changed in 100 kHz
(or 50 kHz) steps in FM and 10 kHz (or
9kHz) in AM when the tuning selector
button is pressed in single steps.
Se tne @ If this button is held continuously for
bA LAL PE? more than 0.5 seconds, the frequencies
pe I are scanned automatically. (FM auto
tuning mode)
When a broadcast is received, scanning
stops.
t
“ COWN TUNING UP »
When the frequency is known -Direct
tuning
1. Press the FM or AM button.
2. Press the DIRECT TUNING/DELETE
button.
The “-- -- will flash 16 seconds in the
frequency display.
3. Enter the frequency with the number
buttons while the cursor are flashing.
Example: 88.10 MHz 838-1 0/10
@ When receiving AM broadcasts with a
9 kHz step (this depending on your
region), you can enter the frequency
directly.
With 10 kHz steps, entering a number
for the 10 kHz digit will set the | kHz
digit automatically to 0.
e if you enter a frequency that does not
have a station, this unit will automati-
cally tune to the next station immedi-
ately below that station.
e [f you enter a frequency that is out of
range, this unit will return to the previ-
ous frequency. If this happens, repeat
the procedure.
TM MUTE FTUNES a
oN STESED
FM MULTE bTUNED
ON STERE!
=
7 8TU | 8 VWX 9¥Z—
FM MUTE TUNED 4
O10 ¥: ON STERED
L_ hA oe
PoP Eee FLL
14