Onkyo TX-8210 - Schematic Diagram (Part A); Schematic Diagram (Part B); Schematic Diagram (Part C)

Entering station names
Characters can be entered during reception of an FM or AM broadcast station.
This function enables you to memorize a maximum of 8 characters consisting of alphabetics, some symbols and numbers, for instance, rep-
resenting broadcasting names, for cach preset station.
If you attempt to enter characters while recetving an FM broadcast RDS station, “RDS...PS” is displayed and characters cannot be entered.
Characters which can be input
ABCDEFGHIJKLMNOPQRSTUVW
XY¥Z1234567890-_x/
Note: indicates a space.
To name ICH of GROUP B as “ONKYO”, for example, operate
as follows. (Example: FM broadcast at 98.00 MHz has been mem-
orzed into 1CH of GROUP B).
———— 1. Press the GROUP button until B is displayed, then press
oo | the [ABC button to select 1 CH.
Paty ar?
file id
idLL ce . The memorized broadcast station is received.
2. Press the CHARACTER button.
The frequency in the display goes off and “_” flashes.
3. To enter O from “ONKYQO”, press the SMNO button.
Pressing the button each time changes the character from 5 to
M,N, and O, one at atime. Select O.
e ~_” will move to the next character. Uf you do not press the
number button for one second, ~_” will automatically move to
the next position. )
@ When you want to delete a character, press the DIRECT TUN-
ING/DELETE button. The character is deleted, and the charac-
ters on the right move to the left by one space.
4. Repeat step 3.
To enter N from “"ONK YO”, press the SMNO button and select
‘ifr dt N.
Vis f Liss To enter K from “ONKYO” press the 4JKL button and select
K.
5. Press the CHARACTER button.
e If you have not pressed a button for 16 seconds, the operation
PER
Ihe
7
FI
will
complete
automatically.
Ltinths
ot 74
Press the CHARACTER button.
While pressing the MEMORY button, press the FM MUTE/
THe eae MODE button.
All the characters entered for this station will be cleared.
PRM CTL mL SED
Oh SOPREID
v4 _ Press the GROUP and number buttons to recall the desired
LiiMik did preset number.
Press the CHARACTER button.
The first character and “_” flashes alternately.
Shwe oe ae :. Press the < DOWN TUNING UP > button and move “*_”’ to
DOWN TUNING UP 4
i
_IL_J
Mth
ite
TP
the
character
you
want
to
change.
i
“y
Ltives tL oo *~_* moves to the right when pressing the UP » button and
moves to the left when pressing the < DOWN button.
Enter the desired character.
on Monee The previous character is replaced with a new character.
». Press the CHARACTER button.
MME BTN @
mM STEAE
Pah the se FY
Pfisvis dt hi
17