Onkyo TX-8210 - Schematic Diagram (Part I)

20
Recording a source
Please read the instruction manuals con-
cerning the operation of each unit.
1. Insert a blank tape into the tape deck.
2. Press the button of the source from
which you want to record.
@ When FM or AM is selected. set the
tuner to the station you want to record
from.
@ When TAPE-!/VIDEO is selected. it
will record to the TAPE-2 REC jacks.
@ When either FM, AM, PHONO or CD
is selected, you are able to record to
both the TAPE-I| and TAPE-2 REC
jacks.
3. Put the tape deck in the recording
| mode. Begin playing the source.
Signal
Flow
TX-8210/R
_
Set
the
proper
recording
level
using
the
_ controls on the tape deck used for record-
ing. Also, during recording and dubbing
operations, if any controls (bass, treble
etc.) on this unit are changed during
recording and dubbing operations, the tone
effects will not change.
Recording Playback
1. Load the original tape in deck 1 and
the blank tape in deck 2.
2. Press the TAPE-I/VIDEO button.
3. Put tape deck 1 in the playback mode
and tape deck 2 in recording mode.
The source signal can be monitored
through the speakers or headphones
when TAPE-2 MONITOR is turned off.
If tape deck 2 has three heads, the just-
recorded signal can be monitored (when
the TAPE-2 MONITOR is turned on).
Refer to the tape deck instruction manual
for more details.
Signal Fiow
TX-8210/R
Playback Recording
Tape deck
TAPE-1/VIDEO
Tape deck (TAPE-2)