Firmware Update for the TX-NR515, TX-NR616, HT-RC460
& HT-R791 (HT-S7500)
2. Supports Onkyo Remote2 for iOS version: 1.30 or later;
• Adds support audio streaming from iOS device
3. Supports Onkyo Remote for Android version: 1.30 or later;
*it is also necessary to update the App;
4. Adds support of Home Media Function (Samba Server); Playing music files like Apple Lossless via
network/USB becomes possible;
Additional Audio file format
Apple Lossless (.m4a/.mp4/.M4A/.MP4)
• Sampling rates of 8 kHz, 11.025 kHz, 12 kHz, 16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz, 48 kHz, 64
kHz, 88.2 kHz and 96 kHz are supported.
• Quantization bit: 16 bit, 24 bit
DSD (.dsf or .DSF)
• The sampling rate of 2.8224 MHz is supported.
Dolby True HD (.vr/.mlp/.VR/.MLP)*
• Sampling rates of 48 kHz, 64 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz are supported.
*Playing Dolby True HD files at rear USB port is not supported.
Notice:
Limitation of when using UWF-1
1. Only 64 kHz and less sampling rate is supported
2. Dolby TrueHD and DSD is not supported
3. Using rear USB port is not supported
The 8/10 /2012 update will address the following:
1. Improves operation of "Power on" of remote control
The 6/26 /12 update will address the following:
1. Corrects problem of HDMI video output no longer working while the “Network Standby” setting is enabled
*See Important Notice for further details
2. Adds UBT-1 support (only if 6/15 FW update wasn’t done)
*IMPORTANT NOTICE
1. If the current F/W version of your receiver IS listed above, this update will occur in 2 parts.
a. The 1st part of the update WILL CLEAR the settings and restore the unit to factory default
setting. Initial set-up must be performed again including Network setting and Audyssey calibration.
b. Once the network settings are re-established, the 2nd portion of the update will occur. Settings
WILL NOT be cleared as a result of this 2nd portion.
c. It is recommended to proceed with these FW update via USB
2. If the current F/W version of your receiver IS NOT listed above, only the later F/W update will be
processed. Settings WILL NOT be cleared as a result of this portion.
a. It is recommended to proceed with these FW update via USB
Once these updates are completed, the receivers F/W version will be 1110-8106-0300
To Next Page
Loading...
