TX-NR838
EXPLODED VIEWS-1
OVERALL
<NOTE>
No description screw is 3TTB+8B(3BC).
3
15
4
8
3
8
3
3
3
10
3
8
4
8
4
8
Unit : mm
3
8
<NOTE>
U791 = U791A + U791B + U791C + U791D
A105
A401
A421
T901
F6401
F6402
P9000
Q6050Q6051
Q6052 Q6053Q6054
Q6055Q6056 Q6060Q6061
Q6062 Q6063Q6064
Q6065Q6066
A029
x 4 pcs.
A033
x 4 pcs.
A093
A101
P2510
F9002
U0010
U0020
x 3 pcs.
U0030
U0042
U0043
U0050
U0070
U0080
U0090
U0120
U0120A
U0120B
U791B
U791C
U791D
x 2 pcs.
U0011
U0012
U0031
U0032
U0033
U0048
P8651
U791A
P6601A
x 22 pcs.
U792
Information to the user.
Indicate "Contains FCC ID: TX2-RTL8273AS", "Contains IC: 6317A- RTL8273AS" and following informa ion to the host
device installed.
This device complies wi h part 15 of the FCC Rules. Opera ion is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Describe he following sentence to a user's manual of the host device.
[For FCC]
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communica ions.
However, there is no guarantee that interference will not occur in a particular installa ion. If this equipment
does cause harmful interference to radio or television recep ion, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an ou let on a circuit different from hat to which the receiver is connected.
—Consult he dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction wi h any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low
levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person’s
body (excluding extremities: hands, wrists, feet and ankles).
[For IC]
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies wi h Industry Canada licence-exempt RSS standard(s). Operation is subject to he following
two condi ions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of he device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux condi ions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets
RSS-102 of he IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it
deemed to comply without maximum permissive exposure evalua ion (MPE). But it is desirable that it should be
installed and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities:
hands, wrists, feet and ankles).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non
contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement
émet une énergie RF très faible qui est considérée conforme sans évaluation de l’exposition maximale
autorisée. Cependant, cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre
le dispositif rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles).
WiFi & Bluetooth Module has already been certificated by FCC and IC.
Refer to
“EXPLODED VIEWS-2”
This module transmitter does not have RF shielding,
therefore it will be equipped only the tested Audio system
mentioning this document.
Additional test will be required if it will be equipped to the
other devices
WiFi & Bluetooth Module
Heatsink
Rear Panel
3SMH10W.SW+15B(CU)
x 14 pcs.
4TTC+8C(3BC)SR
x 4 pcs.
3TTB+8B(3CM)SR
x 2 pcs.
3P+6FN(3BC)
3P+6FN(3BC)
x 8 pcs.
3TTF+10B(3BC)
x 2 pcs.
3TTB+8B(3CM)SR
Silver Model
x 3 pcs.
4TTB+8C(NI)
4TTB+8C(3BC)
Silver Model Black Model
x 6 pcs.
Except MDC,MJJ
L-40mm
MMA,MMB,MMP only
3TTB+8B(BC)
To Next Page
Loading...
