EasyManua.ls Logo

Onkyo TX-RZ3100 - Power and Unit Operation Issues

Onkyo TX-RZ3100
159 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Power
Cannotturnontheunit
Makesurethatthepowercordisproperlypluggedintothewalloutlet.
Unplugthepowercordfromthewalloutlet,wait2minutesormore,thenplugit
inagain.
Theunitturnsoffunexpectedly
Theunitautomaticallyswitchestostandbywhenthe"Hardware""Power
Management""AutoStandby"settingintheSetupmenufunctions.
(Modelswithbuiltinamplifiersonly)Ifyouplayathighvolumesorallowinput
ofexcessivebass,theprotectioncircuitsintheamplifiercanbetrippedwhich
maysuddenlyturntheunitoff.Trythefollowingifthisoccurs.
Reducethevolume
Selectunder100Hzforeachofthespeakersin"Speaker""Equalizer
Settings"intheSetupmenu,andreducethevolumecomparedtothe
currentsetting.
In"Speaker""Crossover"intheSetupmenu,set"Front"tothecrossover
frequencyvalueotherthan"FullBand"orset"Front"to"FullBand"andset
"DoubleBass"to"On"
(Modelswithbuiltinamplifiersonly)Ifthepowerturnsoffandindicatorsonthe
frontpanelcontinuallyblink,orthefollowingerrormessagesappearonthe
display,theremayhavebeenamalfunctionwiththeamplifierortheprotection
circuitmayhavetripped.
If"CHECKSPWIRE"isdisplayed:
Thewiresinthespeakercablesmayhavetouchtherearpanelorother
wires.Twistthewiresagainproperlyandmakesuretheydonotstickoutof
thespeakerterminalswhenconnecting.
If"FANSTOP"isdisplayed:
Theinternalcoolingfanhasmalfunctioned.Unplugthepowercordfromthe
walloutletimmediatelyandcontactthedealerorourcompany'ssupport.
If"AMPOVERHEAT"isdisplayed:
Thetemperatureinsidetheunithasexceededtheadmissiblevalue.Make
suretheunithasplentyofspaceforventilationaroundit,waitfortheunitto
cooldownsufficiently,andthentryturningitonagain.
If"AMPERR"isdisplayed:
Itispossiblethattheamplifiercircuitsintheunithavemalfunctioned.Wait
foratleastaminuteandthenturntheunitonagain.
Ifthesamesymptomssuchasbeingunabletoturntheunitonhappen
repeatedly,unplugthepowercordfromthewalloutletimmediatelyandcontact
thedealerorourcompany'ssupport.
WARNING:Ifsmoke,smellorabnormalnoiseisproducedbytheunit,unplugthe
powercordfromthewalloutletimmediatelyandcontactthedealerorour
Troubleshooting

Other manuals for Onkyo TX-RZ3100

Related product manuals