Onkyo TX-RZ70 - Page 17

17
Rear Panel
I J K L M N O
P Q R S
I AUDIO IN jacks: Input AV component audio
signals with an analog audio cable.
J GND terminal: Connect the ground wire of the
turntable.
K COMPONENT VIDEO IN jacks: Input AV
component video signals with a component
video cable. (Compatible only with 480i or 576i
resolution.)
VIDEO IN jacks: Input AV component video
signals with an analog video cable.
L ZONE 2 PRE/LINE OUT jacks: Output audio
signals with an analog audio cable connected
to an integrated amplier in a separate room
(ZONE 2).
ZONE B LINE OUT jacks: Simultaneously
output the same audio source as the speakers
(ZONE A) connected to this unit by connecting
this unit to wireless headphones, wireless
speaker transmitter, etc., using an analog audio
cable.
M ZONE 3 PRE/LINE OUT jacks: Output audio
signals with an analog audio cable connected
to an integrated amplier in a separate room
(ZONE 3).
HEIGHT 2 PRE OUT jacks: Connect a power
amplier. ( →p61)
N SUBWOOFER PRE OUT jacks: Connect a
powered subwoofer with a subwoofer cable. Up
to two powered subwoofers can be connected.
See "Connecting the Subwoofer" ( →p41) for
details.
O PRE OUT jacks: Connect a power amplier.
( →p61)
P SPEAKERS terminals: Connect speakers with
speaker cables. Support banana plugs. Use a
plug 4 mm in diameter. Y plug connection is not
supported.
Q IR IN port: Connect a remote control receiver
unit. ( →p76)
R 12V TRIGGER OUT jack: Connect a device
equipped with a 12V trigger input jack to enable
power link operation between the device and this
unit. ( →p77)
S RS232 port: Connect a home control system
equipped with an RS-232C port. For installing
a home control system, contact the specialized
stores.