Onkyo TX-SV424 - Making Speaker Connections; Front Speaker Setup; Center and Rear Speaker Setup

Making speakers connections
1. Open the lever.
2. Insert the wire.
3. Close the lever.
Before making any connections, please
refer to the explanation of “Speaker imped-
ance”.
FRONT FRONT
You
can
connect
two
separate
pairs
of
FRONT SPEAKER A oneness A FRONT speaker systems.
ch. ,
ee
B
SPEAKER
B
Please
connect
each
speaker
according
to
ch.
L ch. ~ the illustration, observing the correct con-
nections for R, L, + and -.
e Do not use unnecessarily long or
extremely thin speaker leads. If the DC
resistance of the speaker leads is too
high, the damping factor will decrease,
adversely affecting the sound quality.
@ When using only one speaker or when
you wish to listen to monaural (mono),
the single speaker should never be con-
nected in parallel to both the nght and
left channel terminals at once.
ANTENAA
iN
G1 = VIDED2- MOTOR .
p)
REAR
SPEAKER SPEAKER
Roch. L ch.
Connect the center speaker and rear speak-
ers (right and left) to the TX-SV424.
This unit is designed to produce optimum
| sound quality when speakers with imped-
(GauTion |[ ATTENTION | Q 8 ’ .
wren} iemmemitis A hes dan hea el # ances within the set ranges are connected.
ee oe = = — —. —
RI
co 4 Please check the following information and
¢ choose speakers with the necessary imped-
ances for the connections.
— a
= = | | FRONT SPEAKERS
A or B: 6 ohms min./speaker
A+B :Can not be used at the same
time.
U.S.A. models:
A or B: 6 ohms min./speaker
A+B :12 ohms min./speaker
; MIDEC — ViOEO-2 -MONITAI
: =] fy oo, «OU +
SWITCHED TOTAL 1000" MAM.
th |
J
et
©
ron
reat
fs
S
:
Sia
0
GHo VIDEO
CENTER CENTER SPEAKER: 8& ohms min.
SPEAKER
REAR SPEAKERS: 8 ohms min./speaker