Onkyo TX-SV424 - Making Antenna Connections; Antenna Cable Adapter Guide; Antenna Cable Splitter Advice; AM Loop Antenna Assembly

Making antenna connections
Outdoor indoor
antenna antenna
\
\ 300 ohms
Connecting the 300 ohm ribbon wire:
Loosen the screws and wrap the wire
around these screws. Then tighten the
screws with a screwdriver.
ribbon wire
Connecting the coaxial cable:
1. With your fingernail or a small screw-
driver, press the stoppers outwards and
remove the cover.
2. Remove the transformer wire A from
slit B and insert it into slit C.
3. Prepare the coaxial cable as shown in
the diagram.
Connect the 75/300 ohm _ antenna
adapter to the coaxial cable.
C4) Insert the end of the cable.
(2) Clamp it in place with pliers.
e@ This adapter is included if your TX-
SV424 is a worldwide model.
Do not use the same antenna for both FM
and TV (or VCR) reception since the FM
and TV (or VCR) signals can interfere with
each other. If you must use a common FM/
TV (or VCR) antenna, use a directional
type splitter linkage type splitter.
To TX-SV424 To TV (or VCR)
Assemble the loop antenna as shown in the
illustration.
. Open the lever.
2. Insert the wire.
3. Close the lever.
12