2
Operation Instruction (GB)
Random code Transmitter
1. Function
1) Use with Wireless Switch Receiver together. Operate simple.
2) Operation code is 24 bit address code and CRC check,repeat probability is 1 / 16,777,216.
3) Every transmitter can control up to 4 channels (1ON,1 OFF,2ON,2OFF…etc).While each channel can control several
receivers.
4) LED indicates the signal transmission status.
5) Max. remote range 30m in open area.
2. Diagram
3. Channel-select
Press and hold“LEARN” key on Wireless Switch Receiver about 3 seconds until LED flash，enter channel-select state;time of
the channel-select state will keep about 15 seconds,now press the key on Transmitter,the LED on Wireless Switch Receiver will
stop flash if channel-select succeed.it will exit the channel-select state after 15 seconds if channel-select defeated.
4. ON/OFF
1) Press the ON key of corresponding Transmitter, the corresponding Receiver output power is ON.after channel-select
complete;press the OFF key of corresponding Transmitter, the corresponding Receiver output power is OFF.
2) Press the ALL-ON key of corresponding Transmitter, the all corresponding Receiver output power is ON.after channel-select
complete；press the ALL-OFF key of corresponding Transmitter, the all corresponding Receiver output power is OFF.
5. Specification
1) Battery:1 pc 23A,12V
2) Radio Frequency: 433.92MHz
3) Max. Range: 30m in open area
Random code Wireless Switch Receiver
1. Function
1) Use with Random code Transmitter together. Operate simple.
2) Operation codeis 24 bit address code and CRC check,repeat probability is 1 / 16,777,216.
3) Have a built-in memory,can remember the memory control information 10 years.
To Next Page
Loading...