BATTERY REMOVAL
Removing the battery is very easy but you need to
take extreme caution when doing anything related to
the battery. Below are the steps to safely remove the
battery for charging it o the bike.
BATTERY INSTALLATION
Follow the installation steps below with extreme care.BATTERY OPERATION
STEP 1: Turn o the battery with the battery switch to
the “OFF” position. Never attempt to unplug the battery
with the battery switch in the “ON” position. Once o
unplug the battery connectors.
STEP 3: Grab both ends of the battery strap and buckle
it back together snugly (adjust for t if necessary). Once
the battery is secure you can turn the battery power to
the “ON” position.
STEP 2: Unlatch the battery strap and gently place the
buckles on the sides of the bike.
STEP 2: Plug in the red battery discharge cables. Do not
be alarmed if you forgot to turn o the battery and the
connectors spark on contact. This is okay a few times
but over time you can wear out your connector.
STEP 3: To fully remove the battery grab the battery
case handle and lift out the front of the battery rst
until it clears the top of the bike. In the meantime make
sure to gently help the battery cables out of the bike.
STEP 1: Always make sure the battery switch is in the
“OFF” position before installing the battery. Place the
back end of the battery on the battery tray rst then let
down the front gently moving the cables into the bike.
To Next Page
Loading...
Need help?
General
