QUICK START GUIDE
STEP 5: To fully remove the battery for charging, grab
the battery case handle and lift out the front of the
battery rst until it clears the top of the bike. In the
meantime, make sure to gently help the battery cables
out of the bike.
STEP 6: Make sure the battery is in the “OFF” position.
Plug in the charger into the wall and then plug in your
battery. The charger light will change from green to
red after the battery is connected. When the battery is
done charging the light will turn green.
STEP 9: Grab both ends of the battery strap and buckle
it back together (adjust for a snug t if necessary). Once
the battery is secure you can turn the battery power to
the “ON” position.
STEP 10: Read the Operating Controls section before
attempting to turn on the bike.
STEP 8: Plug in the red battery discharge cables. Do not
be alarmed if you forgot to turn o the battery and the
connectors spark on contact. This is okay a few times
but over time you can wear out your connector.
STEP 7: After the charge is complete make sure the
battery switch is in the “OFF” position before installing
the battery. Place the back end of the battery on the
battery tray rst then let down the front gently moving
the cables into the bike.
To Next Page
Loading...
Need help?
General
