23
QCC1 gas regulator
This is a clockwise threaded gas fitting. Ensure the tank is fully
turned o and screw the regulator on to the gas tank valve
fitting until tight.
USA / CAN
• The appliance must be installed at least 3.5ft (1 meter) from any flammable materials.
• The oven should be placed on a non-flammable, stable and flat surface.
• Make sure your oven is placed in an area that will not be affected by adverse weather.
• When the diameter of the injector is 0.83mm use the provided 11 WC (28mbar) regulator with Propane LPG cylinder.
• An LPG cylinder shall be of a maximum nominal 20 lb (9.1 kg) fuel capacity.
• Use a suitable provided regulator certified to ANSI Z21.18/CSA 6.3 and a flexible hose certified to ANSI Z21.54/CSA 8.4.
• The regulator shall be installed in such a location that it will not attain a temperature above 130°F (54.5°C)
• The length of the hose must be no more than 2 ft (61cms). Worn or damaged hose must be replaced. Ensure that the
hose is not obstructed, kinked, or in contact with any part of the oven other than at its connection.
• The gas supply hose should be checked periodically and should be replaced if damaged and at least every two years.
• Check all connections for gas soundness.
• Your country’s national requirements will advise you how often to replace the hose. Regularly review these requirements
for your country.
• In the case of blocked venturi immediately turn off burner unit, turn off gas supply, disconnect gas supply and wait until
cooled to removed from oven.
• Ensure the appliance is clear of debris before every use. If any debris does build up use a brush to remove this when
appliance has cooled.
Gas Safety Information
To Next Page
Loading...
