Climate Controls 131
condensation may form and drip
from under the vehicle. If no cooling
or drying is required, switch off the
cooling system for fuel saving
reasons.
Activated cooling might inhibit
Autostops
0 Automatic Engine
Start/Stop Feature 0 137.
Air recirculation system
Press W to activate air
recirculation mode. Activation is
indicated by the LED in the button.
Press
W again to deactivate
recirculation mode.
{
Warning
The exchange of fresh air is
reduced in air recirculation mode.
In operation without cooling the
air humidity increases, so the
windows may mist up from inside.
The quality of the passenger
compartment air deteriorates,
which may cause the vehicle
occupants to feel drowsy.
In warm and very humid ambient air
conditions, the windscreen might
mist up from outside, when cold air
is directed to it. If windscreen mists
up from outside, activate
windscreen wiper.
Maximum cooling
Briefly open the windows so that hot
air can disperse quickly.
.
Switch on cooling A/C.
.
Switch on air recirculation
system
W.
.
Press air distribution switch
E.
.
Set temperature control to
coldest level.
.
Set fan speed to highest level.
.
Open all vents.
Air Vents
Adjustable Air Vents
At least one air vent must be open
while cooling is on in order to
prevent the evaporator from icing up
due to lack of air movement.
Direct the flow of air by tilting and
swivelling the slats. If you do not
want the flow, move the slats to
inside for centre vent and outside
for side vent. The vent has some air
leakages at closed position.
To Next Page
Loading...
