Optergy P864 - User Manual

Figure 1
24 VAC
24 VAC/GND
24 VAC
Ground
Figure 2
24 VDC +
24 VDC -
P864INRev2.0 | © 2020 Optergy page 1 of 2 info@optergy.com | www.optergy.com
P864 Startup Instructions
A quick guide to set up your hardware and software.
Connect Power
3
Warning: Internally this device uses a 24 VAC half-wave rectifier and can only share the same AC
power supply as other half-wave rectified devices.
Set the BACnet MS/TP
MAC address
2
OR
• The MAC address is configured using the 2
rotary switches underneath P864 top cover.
• To release the hinged cover press round
plastic buttons inward and hinge the cover
open.
• To set the MAC address, rotate the switches
to the desired locations.
e.g. to set MAC address 25, move the X10
rotary switch to position 2 and the X1 rotary
switch to position 5.
• MAC address range is 0-99, note: 0-0 is 99.
Set the BACnet IP &
TCP/IP Address
• The IP address is configured using the 2
rotary switches underneath the P864 top
cover.
• To set the IP address, rotate the switches
to the desired locations
e.g. to set IP address to 192.168.1.20,
move the X10 rotary switch to position 2
and the X1 rotary switch to position 0.
• Switch positions allow for settings 1-100,
note: 0-0 is 100.
Unbox hardware
1
• The P864 default configuration has BACnet IP enabled and MS/TP.
Routing is disabled. This means it will scan on IP and/or MSTP.
• Remove the real time clock battery isolator tape.
x10 x1
Set the BACnet IP
&
Figure 3
TCP 2 (PoE+)
Power over Ethernet (PoE)
18 Watts
TCP 2 (PoE+)
1
2
4
5
7
8
3
6
Power
Sourcing
Equipment
1
2
4
5
7
8
3
6
Powered
Device
Blue = Data Red = Power
MODE B 10/100 TX only
Mode B
Pins 7,8+
4,5-
P864 Rev1
P864 Rev2
P864 Rev1
P864 Rev2
Mode A
Pins 1,2+ Voltage
3,6-
P864 Power can be supplied by:
• 24 VAC ½ wave (grounded secondary) 24 W max.
Refer to Figure 1.
• 24 VDC Power Supply 24 W max. Refer to Figure 2.
• PoE+ (Power over Ethernet). Refer to Figure 3.
o 802.3 at, Type 2, Mode A or B.
o Not compatible with 802.3 af
o P864 PoE+ on TCP/IP 2
o PoE+ can be loaded up to 24 W max.
P864 has an onboard 24VDC power supply:
• Stay within power budget (24 W).

Optergy P864 Specifications