Opticon M-10 - 6 Electrical Specifications; USB Power Supply; AC Adapter Specifications; Input Specifications

M-10
Specifications Manual
7
6. Electrical Specifications
6.1. USB Power Supply
Power supply : 500 mA High-Power
Current consumption : 420 mA ( max ) during reading operation
: 150 mA ( typ ) in standby
* The current consumption was measured at 25°C.
6.2. AC Adapter Specifications
For RS-232C (D-Sub 9pin) model
6.2.1. Input Specifications
Power supply voltage : AC 90 ~ 265 V
Power supply frequency : 47 ~ 63 Hz
Maximum current : 0.5 A ( max )
6.2.2. Input Specifications
Output voltage : 6.0 V ±5% / Output current: 0 ~ 2.0 A ( max )
Power ripple : 100 mV p-p ( max, rated load )
7. Interface Specifications
The M-10 supports four types of interfaces; USB-HID, USB-COM and RS-232C.
7.1. USB
The USB interface models have two specifications: HID (Human Interface Device Class) and COM
(Communication Device Class). With USB-COM model, VCP (Virtual Communication Port) allows
virtual serial communication and the commands can be transmitted from the host computer.
* Multi byte character data or images can be transmitted via USB-COM interface.
7.1.1. USB Interface Specifications
Power supply : 500mA (High-Power).
Speed : USB2.0 Full speed ( 12 Mbps )
Interface : USB-HID / USB-COM (VCP)
* The USB model is bus powered and no AC adapter is required.
* Images cannot be transmitted via the USB-HID interface.
* Multi byte character data can be transmitted via USB-HID interface with settings.
* Make sure to connect to a High-power bus (500 mA max) USB terminal.