M-10
Specifications Manual
12
8.2. Aiming Pattern
The aiming is used for the following purpose:
1. Light source to indicate the appropriate reading range
2. Light source for auto trigger operation
The aiming specifications are as follows:
- An optical axis of imaging field of view and the center of horizontal aiming width coincide at a
distance of L=50±20 mm from the front edge of the scanner.
- The horizontal aiming width to the horizontal width of imaging filed of view at a distance of L=60
mm is 80%±10%.
Figure 9: Aiming Pattern and Imaging Range
8.3. Scanning Area
The range is ±5% from the following values.
L: Distance from the front edge
of scanner
[mm] 0 50 100 150
H: Horizontal reading area [mm] 48 85 122 165
V: Vertical reading area [mm] 31 54 78 105
To Next Page
Loading...
