Opticon NLV-4001 - 15.3 Default Setting (Part 2: Read Options, Illumination LED, Trigger, Buzzer)

NLV-4001
2nd
25
SPECIFICATIONS MANUAL
15.3 Default Setting (Part 2: Read Options, Illumination LED, Trigger, Buzzer)
Item
Default
Setting of number of characters
Off all codes
Read mode
Single read
Multiple read reset time
500 msec
Add-on wait mode
500 msec
Multiple label read (code only)
Disable
Multiple column read
Disable
Redundancy (*1)
Read 1 time (redundancy = 0)
Illumination LED
Enable
Trigger repeat
Disable
Read time
2 sec
Margin check
Normal
Buzzer duration
50 msec
Buzzer tone
3 kHz (single tone)
Buzzer loudness
Volume 1 (Maximum.)
Buzzer timing
Before transmission
Startup buzzer
Enable
Status LED duration
200 msec
(*1) The redundancy count for the following specific digits of bar codes will be
[the set number of times + 1].
Symbology
No. of Digits
Code 39
5 or less
Codabar(NW-7)
All
IATA
8 or less
Industrial 2 of 5
8 or less
Interleaved 2 of 5
8 or less
MSI/Plessey
4 or less
Code 11
5 or less
TELEPEN
8 or less
S-Code
7 or less
Matrix 2 of 5
8 or less
Chinese Post Matrix 2 of 5
8 or less